Airbag Unit (Passenger's Side), Remove and
Install
Remove
1. |
Disconnect battery
Note: Wait for 1 minute
until capacitor has discharged
|
2. |
Glove Compartment, Remove and Install
|
3. |
Remove airbag unit
• |
Unlatch and disconnect wiring harness plug (1) at airbag
unit
|
|
|
|
4. |
Lift airbag unit from brackets of the steering crossmember and
remove through the glove compartment cut-out on the passenger's
side
|
|
|
Important: Always set aside
airbag unit with screw connection side downwards.
|
5. |
|
Install
6. |
Install airbag unit
• |
Connect and latch wiring harness plug
|
• |
Inset airbag locking mechanism (1) in steering crossmember
brackets (2) and screw firmly in place
– |
Tighten 2 bolts (2) 8 Nm
|
|
|
Important: Check correct
engagement of the wiring harness plug.
|
7. |
|
|
|
8. |
Install glove compartment
|
10. |
Perform readiness check
|
11. |
Program volatile memories
|
|