Rear Reaction Member, Replace (Z 17 DTH, With Air
Conditioning, LHD)
Remove
Important: On vehicles with ESP -
the steering angle sensor loses its basic adjustment each time the
battery is disconnected. It must be recalibrated
|
2. |
Disconnect battery
|
4. |
Remove exhaust system
Important: When removing the
centre muffler, a catalytic converter, an exhaust manifold or an
exhaust manifold with catalytic converter, secure the part of the
exhaust system that remains on the vehicle against uncontrolled
sagging. The exhaust system piece with the flex pipe inside can be
secured to the vehicle underbody for this purpose using suitable
material such as wire . Bends in the flex pipe with an angle of as
little as 5 – 10 degrees from the intended installation
position may result in damage with subsequent total failure of the
flex pipe
|
• |
Remove front exhaust pipe
|
|
|
|
5. |
Attach exhaust system
Note: Second person
required
|
6. |
Remove rear reaction member
• |
Detach refrigerant line (2)
|
|
|
|
Install
7. |
Install rear reaction member
• |
Tighten new bolted connection 80 Nm +
45° - 60°
|
• |
Tighten 2 new bolts 80 Nm + 45° -
60°
|
|
8. |
Attach exhaust system
Note: Second person
required
• |
Attach retaining rubber (5x)
|
|
9. |
Fasten front exhaust pipe
|
12. |
Program volatile memory
|
|