Engine Oil with Filter Change (Z 17 DTH, with AC,
LHD)
Remove
Note: Before the oil
change, the customer should be informed of the ECOService-Flex and
ECOService options
2. |
Remove oil filter element
• |
Place collecting basin underneath.
|
• |
Remove oil filter housing cover (1)
|
|
3. |
Raise vehicle all the way
|
4. |
Drain engine oil
• |
Place collecting basin underneath.
|
|
|
|
Install
5. |
Fit drain bolt
• |
Tighten oil drain bolt
Steel bolt
|
to engine number - 1493404
|
78.4 Nm
|
Aluminium bolt
|
from engine number - 1493405
|
20 Nm
|
|
|
6. |
Lower vehicle all the way
|
7. |
Install oil filter element (1)
• |
Install 3 new gaskets (2) and (3)
|
• |
Tighten oil filter housing cover 25
Nm
|
|
|
|
8. |
Top up engine oil
• |
Observe specified engine oil quantity
|
• |
Start engine and allow to run until oil pressure telltale
extinguishes.
|
• |
Check engine oil level, if necessary correct.
|
|
9. |
Reset service interval
|
|