Replace throttle valve module (Z 10 XE, Z 10 XEP,
without air conditioning, LHD)
Remove
2. |
Remove suction pipe (4)
• |
Detach engine venting hose from cylinder head cover (5)
|
• |
On Z 10 XEP: Remove air intake hose
|
• |
Disconnect 2 wiring harness plugs
– |
Hot film mass air flow sensor (2), tank vent valve (1)
|
|
• |
Remove hot film mass air flow meter (3)
|
|
|
|
3. |
Disconnect throttle valve module wiring harness plug (2)
|
4. |
Detach 2x throttle valve module preheater hoses (3, 4)
|
5. |
Detach throttle valve module
|
|
|
Install
6. |
Clean sealing surfaces
|
7. |
Install throttle valve module
|
8. |
Attach 2x throttle valve module preheater hoses
|
9. |
Connect throttle valve module wiring harness plug
• |
Switch ignition on for 30 seconds (without engine running)
|
|
10. |
Install suction pipe
• |
Install hot film mass air flow meter
|
• |
Connect 2 wiring harness plugs
– |
Hot film mass air flow meter, tank vent valve
|
|
• |
On Z 10 XEP: Fit air intake hose
|
• |
Attach engine vent hose
|
|
11. |
Check and correct coolant level
|
|