J715100 DIS Ignition Module, Replace (Z 14 XE, Z
16 YNG with AC, RHD)
1. Open bonnet
2. Remove engine cover.
- Unscrew oil filler pipe cap
- Remove 2 bolts
- Screw on oil filler pipe cap
3. Remove ignition module
- Disconnect wiring harness plug
- Remove 4 bolts
- Remove using KM-6009 (1)
- Caution: Do not tilt
4. Install ignition module
- Remove KM-6009
- Tighten bolts (8 Nm / 6 lbf. ft.)
- Connect wiring harness plug.
5. Install engine cover.
- Unscrew oil filler pipe cap
- Tighten bolts (8 Nm / 6 lbf. ft.)
- Screw on oil filler pipe cap
6. Close bonnet
|
|
|