|
Gaiter on Manual Gearshift Lever, Replace
(F13+/F17+)
 Remove
| 1. |
Remove the gaiter cover (1) from the centre console
|
| 2. |
Unclip the reverse gear inhibit connection (2) from the
gearshift knob.
|
| 3. |
Remove gearshift knob
| • |
Push retaining disc (3) upwards
|
| • |
Pull off knob with gearshift lever cup
|
|
|
|
| 4. |
Detach gearshift rod from relay point
|
|
|
| 5. |
Remove front exhaust pipe
| • |
Separate oxygen sensor wiring harness plug
|
| • |
Release clamp
| – |
Separate plug connection
|
|
|
| 6. |
Loosen gearbox extension housing
|
| 7. |
Detach heat shield
| • |
Remove gearbox extension housing with heat shield
|
|
|
|
| 8. |
Detach gearshift rod bellows (1) with gearbox extension housing
gasket
|
|
|
Install
| 9. |
Attach gearshift rod bellows with gearbox gasket
|
| 10. |
Insert gearbox installation aid
| • |
Insert guide sleeve with tab (1) into the gearbox extension
housing at the front left
|
| • |
Insert guide sleeve without tab (2) into the gearbox extension
housing at the rear left
|
|
|
|
| 11. |
Install gearshift actuator assembly with heat shield
| • |
Tighten 4 bolts (1) 22 Nm
Note: Pay attention to
the tightening sequence. First, the rear left bold (guide sleeve
without elongation hole), then the front left (guide sleeve with
elongated hole), then the right side.
|
|
| 12. |
Fasten the heat shield
|
|
|
| 13. |
Install front exhaust pipe
| • |
Fasten clamp
| – |
Connect plug connection
|
|
| • |
Connect oxygen sensor wiring harness plug
|
|
| 14. |
Transmission Shift Linkage, Adjust 
|
|
