vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Replacing the relay box, Body Control Module (BCM), RHD > < Replace engine compartment electronics (UEC)

Corsa D

Replacing the relay box, Body Control Module (BCM), LHD

Important:   When replacing the control unit, before removing the control unit carry out a "Reset" using TECH 2.

  Remove

1.   Disconnect battery
2.   Detach the lower instrument panel padding (1)
•   Open 2 panels (3)
•   Unscrew 2x bolts (2)
•   Remove from the guide
Object Number: 10679731 Size: DEFAULT


3.   Disconnect relay support
•   Disconnect 4 wiring harness plugs (2)
•   Unclip wiring harness
4.   Remove relay support
•   Unscrew 3x bolts (1)
•   Take out relay support
– Release 2x wiring harness plugs (3) and disconnect
Object Number: 10680851 Size: DEFAULT


  Install

5.   Install relay frame
•   Connect and lock 2x wiring harness plugs
•   Tighten 3x bolts
6.   Connect relay support
•   Attach wiring harness
•   Connect and lock 4x wiring harness plugs
7.   Mount the lower instrument panel padding
•   Fix wiring harness plug
•   Insert into guide
•   Tighten 2 bolts 5.5 Nm
•   Close the panel
8.   Connect battery
9.   Program volatile memories
Note:   When replacing the control unit, after installing the control unit, execute "Program" with TECH 2.

Replacing the relay box, Body Control Module (BCM), RHD > < Replace engine compartment electronics (UEC)