vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Replace side airbag wiring harness (OPC) > < Replacing the relay box, Body Control Module (BCM), LHD

Corsa D

Replacing the relay box, Body Control Module (BCM), RHD

Important:   When replacing the control unit, before removing the control unit carry out a "Reset" using TECH 2.

  Remove

1.   Disconnect battery
Object Number: 10679567 Size: DEFAULT

2.   Remove lower foot well panelling, passenger side (3).
•   Unscrew bolt (1)
•   Unclip clip (2)
•   Remove from the guide

Object Number: 10678563 Size: DEFAULT

3.   Remove glove compartment
•   Unscrew 4 screws (1) and (2)
•   Disconnect the wiring harness plug, glove compartment lighting

4.   Disconnect relay support
•   Disconnect 4 wiring harness plugs (2)
•   Unclip wiring harness
5.   Remove relay support
•   Unscrew 3x bolts (1)
•   Take out relay support
– Release 2x wiring harness plugs (3) and disconnect
Object Number: 10680851 Size: DEFAULT


  Install

6.   Install relay frame
•   Connect and lock 2x wiring harness plugs
•   Tighten 3x bolt 5,5 Nm
7.   Connect relay support
•   Attach wiring harness
•   Connect and lock 4x wiring harness plugs
8.   Fit glove compartment
•   Connecting the wiring harness plug, glove compartment lighting
•   Tighten 4x bolts
9.   Install lower foot well panelling, passenger side.
•   Insert into guide
•   Tighten bolt
•   Clip in clip
10.   Connect battery
11.   Program volatile memories
Note:   When replacing the control unit, after installing the control unit, execute "Program" with TECH 2.

Replace side airbag wiring harness (OPC) > < Replacing the relay box, Body Control Module (BCM), LHD