|
Remove drive disc or flywheel – see operation "Drive Disc,
Remove and Install" or "Flywheel, Remove and Install". Lever seal
ring (1) out with suitable tool.
Caution
Do not damage sealing surfaces.
 Clean
Clean sealing surfaces and remove gasket remnants.
Install
Lightly coat sealing lip of seal ring with silicone grease
(white) and press over Protective Ring KM-635-1. Drive seal ring
into cylinder block with KM-635-2 (2) and KM-535 (3). Install drive
disc or flywheel – see operation "Drive Disc, Remove and
Install" or "Flywheel, Remove and Install".
|
