Note: For vehicles
with electronic accelerator pedal the kickdown is electronically
controlled and cannot be adjusted.
In vehicles with 4 cylinder petrol and V6 engines:
Remove
Remove retaining clamp (1) from throttle cable bracket.
Adjust
Align outer sleeve of cable (2) by pulling or pushing in, so
that the cable is loose but without play. Insert retaining clamp
behind washer.
Inspect
Kickdown is detected when accelerator pedal is depressed
(pressure point).
For vehicles with 25 DT/X 25 DT engine:
Remove
Turn stop sleeve below pedal by 90° to the left (1) and
remove – arrow (2) points towards driving direction.
Install
Push lower edge of stop sleeve (1) in position "3" (arrow points
forwards "4") onto holder (5) until the lower edge of stop sleeve
is in area "2".
Install suitable spacer (see example "2") of 7±0.25
mm/2.8±0.01 in. thickness (4), fasten with insulating tape
to stop sleeve if necessary.
Adjust
Push pedal down to kickdown end position "1"; the stop sleeve
engages in the correct position. Release pedal and remove spacer.
Lock stop sleeve by turning by 90° to the right (3) –
arrow (5) points towards driving direction.
