|
Remove transmission fluid pan (intermediate housing) – see
operation "Transmission Fluid Pan (Intermediate Housing), Remove
and Install and/or Seal, Replace". Disconnect wiring harness plug
(1) at pressure regulator solenoid valve. Disconnect wiring harness
plug (3) at converter clutch solenoid valve. Disconnect 4-pin
wiring harness plug (2) at intermediate housing by unlocking with
small screwdriver.
Caution
If metal or lining residue was found when draining fluid,
replace solenoid valve pressure regulator.
Install
Connect wiring harness plugs to solenoid valves (1, 3). Connect
4-pin wiring harness plug (2) to intermediate housing. Ensure
correct routing of wiring harness.
|
