Eos (1F7) V6-3.2L (BUB) (2008)
-
Make sure the alignment sleeves - 2 and 3 - are installed.
-
Install the seal - 4 - in the cover.
-
Clean the old sealing compound from the 3 mm holes in the cylinder head gasket - arrows -.
-
Fill the 3 mm holes in the cylinder head gasket with sealant (D 176 501 A1). Apply sealant (D 176 501 A1) to the sealing surfaces on the cover
and install the cover immediately.
-
Install the camshaft front cover bolts - arrows - and tighten lightly.
-
Tighten the M8 bolts - item 8 -=> [ Bolt ] See: Cylinder Block Assembly/Balance Shaft Chain/Service and Repair to 23 Nm and tighten the M6