Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-197001.png)
Convertible Top Position Sensor / Switch: Service and Repair
Roof Pillar Front Position Sensors
Roof Pillar Front Position Sensors
‹› All screws are microencapsulated and must always be replaced.
-
Open roof.
-
Remove A-pillar trim.
-
Remove screw - 2 - and remove sensor - 1 - from lock fitting - 4 -.
When replacing sensor, disconnect wire - 3 - approximately 350 mm from sensor. After repairing wiring harness, wiring must be secured in harness
again.
Tightening specification for screw - 2 -: 3 Nm.
Roof Pillar Lock Sensors
Roof Pillar Lock Sensors
‹› All screws are microencapsulated and must always be replaced.
