| –
| Cut off tube nozzle at forward marking (Ø of nozzle approx. 3 mm). |
| –
| Apply silicone sealing compound, as shown, to clean sealing surface on sump. Sealant bead must be: |
| t
| Run bead along inner side of bolt holes -arrows-. |
Note | The sealing compound bead must not be thicker. Otherwise excess sealing compound will enter the sump and can block the oil suction line strainer. |
| –
| Install sump immediately and tighten all sump bolts lightly. |
Note | Let sealing compound dry for approx. 30 minutes after installing oil sump. Only then fill engine oil. |
| –
| Tighten oil sump bolts to 15 Nm. |
| Further assembly is basically the reverse of the dismantling procedure. |
| –
| Tighten sump/gearbox bolts to 45 Nm. |
| –
| Tighten oil sump to oil return supply line bolts to 10 Nm. |
|
|
|
