volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing drive plate > < Removing and installing crankshaft sealing flange (flywheel end)

Golf Mk5

Removing and installing flywheel
Removing and installing flywheel
Special tools and workshop equipment required
   
t  Counterhold 3067
Removing:
  Note
To avoid damaging the dual-mass flywheel during removal, the bolts -B- must not be removed using a pneumatic or impact driver. The bolts -B- must be unscrewed by hand without power tools.
  W00-0026
–  Turn the flywheel -A- so that the bolts -B- align centrally with the holes -arrows-.
–  When removing bolts -B-, make sure that screw heads do not jam on flywheel.
  A30-0102
–  Insert counterhold -3067- in hole on cylinder block.
–  Mark position of flywheel in relation to engine.
–  Unbolt flywheel.
Installing:
Installation is carried out in the reverse order. When installing, note the following:
–  Renew bolts.
Specified torque
  A13-0570
Component Nm
Dual-mass flywheel to crankshaft60 + 90°1)

1) 90° equals a quarter of a turn
   

Removing and installing drive plate > < Removing and installing crankshaft sealing flange (flywheel end)