Jetta Sedan L5-2.5L (CBTA) (2009)
/Page-760002.png)
-
Pull out flange shaft with spring.
-
Pry out sealing ring using screwdriver - A -, while doing this support screwdriver at assembly tool (3253/2).
‹› Do not damage sleeve, otherwise leaks will occur.
‹› If damaged, replace sleeve --> [ Pry out sleeve using a screwdriver ] See: Service and Repair/Overhaul/Transmission Housing and Clutch Housing,
Servicing
Installing
-
Drive new seal in as far as the stop; be sure not to distort seal.
