Vehicle electricsRemoving and installing battery
| Removing and installing battery |
WARNING | Danger of injury! Comply with the warning notices and safety regulations → Chapter! |
|
| Replacing battery on vehicles with start/stop system: |
| Because of its higher deep-cycle resistance, only a special starter battery is used in vehicles with a start/stop system. |
| When renewing the starter battery, note correct part designation in → ETKA. Starter batteries for use in vehicles with a start/stop system are marked with „AGM“ (Absorbent Glass Mat) or „EFB“ (Enhanced Flooded Battery). |
| After renewing battery the new battery data must be entered into the battery monitor control unit -J367-. Adapting battery data → Chapter. |
| Battery recharging or jump starting on vehicles with start/stop system: |
| When recharging or jump starting vehicles with start/stop system, note the following: first connect charging cable to battery positive terminal, then body earth. This ensures that the battery sensor is not bridged. The direct charging of the battery on the negative terminal clamp means that the battery sensor is shunted and the battery data are not registered by the sensor while charging. Then, the values concerning the battery state saved in the battery monitor control unit -J367- do not correspond to the values of the charged battery. |
|
|
|
03 General
