volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing rear seat belt end anchor > < Removing and installing front belt buckle

Up!

Removing and installing rear three-point seat belt
Removing and installing rear three-point seat belt
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1331-
Removing
  Note
Removal and installation are described for the left vehicle side. The removal and installation are analogous for the right side.
–  Remove bench seat → Chapter.
–  Remove rear seat backrest → Chapter.
–  Remove side trim → Chapter.
–  Remove load compartment side trim → Chapter.
–  Remove outer rear seat belt guide anchor → Chapter.
–  Remove C-pillar trim → Chapter.
  W00-0427
–  Unscrew bolt -1- (40 Nm) and remove belt guide anchor -2- from body.
  N69-10420
–  Unscrew bolt -1- (40 Nm) and remove belt inertia reel -2- from bodywork mounting.
Installing
–  Install in reverse order of removal.
  N69-10421

Removing and installing rear seat belt end anchor > < Removing and installing front belt buckle