volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing bulkhead insulation > < Removing and installing floor covering

Up!

Removing and installing floor insulation
   
Removing and installing floor insulation
Removing
–  Switch off ignition.
–  Remove lower A-pillar trim on driver side → Chapter.
–  Remove lower A-pillar trim on front passenger side → Chapter.
–  Remove lower steering column trim → Chapter.
–  Remove lower left and right B-pillar trim → Chapter.
–  Remove front seats (driver and front passenger sides) → Chapter.
–  Remove bench seat → Chapter.
–  Remove centre console → Chapter.
4-door model
–  Remove lower left and right C-pillar trim → Chapter.
2-door model
–  Remove left and right side trim panel → Chapter.
All vehicles
–  Remove left and right sill moulding → Chapter.
–  Remove accelerator module → Fuel supply; Rep. gr.20.
–  Remove floor covering → Chapter.
–  Detach floor insulation -1- all round.
–  Raise floor insulation -1- and remove from vehicle (folded along longitudinal axis).

Installing
  Note
t  Carry out a visual inspection to confirm correct installation location, e.g. mountings for seat anchors must mate appropriately.
t  Before installing, check all fasteners for damage and renew if necessary.
Install in reverse order of removal. When doing this, observe the following:
–  Pre-position floor insulation -1-, folded along longitudinal axis, in vehicle.
–  Unfold floor insulation -1- in vehicle and fit.
   

Removing and installing bulkhead insulation > < Removing and installing floor covering