volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing sill moulding, 2-door model > < Removing and installing sill moulding

Up!

Removing and installing sill moulding, 4-door model
Removing and installing sill moulding, 4-door model
Special tools and workshop equipment required
   
t  Removing wedge -3409-
  Note
t  Removal and installation are described for the left vehicle side. Follow same instructions for the right side as appropriate.
t  Removal and installation for vehicles with belt anchor tensioner are analogous.
  W00-0016
Removing
–  Pull sill panel moulding -1- out of front side member and beading of door seal.
–  Release guides for sill moulding -1- from lower B-pillar trim.
–  Pull out sill panel moulding -1- from rear side member and beading of door seal.
–  Remove sill moulding -1- with retaining clip -2- from vehicle.

Installing
  Note
t  Before installing, check all fasteners for damage and renew if necessary.
t  Following installation, ensure that trim is positioned in door seal beading.
Install in reverse order of removal.
   

Removing and installing sill moulding, 2-door model > < Removing and installing sill moulding