volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing engine speed sender > < Removing and installing knock sensor

Up!

Removing and installing Hall sender
Removing and installing Hall sender
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1331-
Removing
Fitting location → Item.
–  Pull hose -1- off air filter housing.
  W00-0427
–  Pull air filter housing upwards off studs at positions -2- and -3-.
–  Push air filter housing and intake connecting pipe in -direction of arrow- out of mounting -4-.
–  Remove air filter housing from engine compartment.
  N15-10801
–  Release and pull off connector -2-.
–  Remove bolt -arrow-.
–  Remove Hall sender -G40--1-.
Installing
Install in reverse order. In the process, note the following:
Renew seal → Item if damaged.
  N28-10123
Specified torque:
ComponentSpecified torque
Hall sender -G40-10 Nm
Air filter → Chapter „Air filter“

   

Removing and installing engine speed sender > < Removing and installing knock sensor