Up!
| Removing trim element |
Note| The trim element cannot be removed without causing damage to the element. |
| – | Remove clamping washers -2- on inner side of alloy wheel. |
| – | Heat outer side of trim element -1- with hot air blower -V.A.G 1416-. |
Caution
|
| – | Release trim element -1- on inner side of alloy wheel using wedge -3409-. |
| – | Grasp under a corner on the outside and pull trim element -1- forcefully off alloy wheel. |
Note| t | Cut back adhesive PUR beads on alloy wheel. |
| t | Residual material is used as a bonding base for the new trim element. |
| t | The new trim element can be installed immediately → Chapter. |
