V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Remove the thermostat housing.
Note! Work very carefully to avoid damaging the contact faces.
Cleaning
Cleaning
Clean the gasket faces for
-
the manifold. Check that the studs are tightened.
-
the coolant bypass channel
-
the thermostat housing.
-
the intake manifold
-
the cylinder block
-
camshaft cover.
Blow the oil ducts clean.
Note! Use a razor blade or a gasket scraper and gasket solvent P/N 1161 440.
Warning! When using gasket solvent, work shall be done in a fume hood or by an air extractor!
Cylinder head gasket, installing
Tightening torque
For tightening torques not in the text, see Tightening torque See: Specifications/Mechanical Specifications/Tightening Torque.
Setting up the engine
Position the crankshaft
Remove the starter motor mounting screws. Pull out the starter motor and place it to one side.
Remove the blind cover plug
Turn the crankshaft slightly clockwise.
Install crankshaft stop 999 5451 ADJUSTMENT TOOL See: Tools and Equipment/999 5451 Adjustment Tool. Ensure that it bottoms out against the
