V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
cylinder block.
Turn the crankshaft counter-clockwise until it stops against the crankshaft stop
Check that the marking on the crankshaft timing gear pulley corresponds with the marking on the oil pump.
Installing the cylinder head
Ensure that all studs at the exhaust ports are tightened.
Lubricate the studs with paste 116 1408.
Install a new cylinder head gasket.
Install the cylinder head
Lubricate and install all the screws. Use new screws.
Tighten the screws in the order illustrated
Tighten the screws in the following order:
1. 20 Nm
2. 60 Nm.
3. Angle tighten 130°. Use protractor 951 2050 BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protractor.
Installing tappets and camshafts
Lubricate the valve guide wells.
Install all the tappets.
Lubricate the camshaft bearing seats.
Install the intake camshaft. Ensure that the groove at the back of the camshaft is above an imaginary centre line.
Position the exhaust camshaft. Ensure that the groove at the back of the camshaft is below an imaginary center line
Applying liquid gasket
