V70R L5-2.5L Turbo VIN 52 B5254T4 (2007)
-
Pull the heat shield all the way up to the heater so that the joint and plastic moulding are covered completely.
Note! It is important that the heat shield covers the entire joint with the engine.
-
Secure the heat shield around the heater cable using a gray, heat-resistant tie clip around the bottom of the shield.
Applies when heater only is installed
-
Remove the existing nut from the steering box
-
Fit the bracket for mounting a branch connector and cables
-
Fit the locknut from the kit and torque to 48 Nm (36 lbf.ft.)
-
Attach the first tie clip to the power steering line. In the absence of a servo fluid cooling line, drill out the first hole to 6.5 mm (1/4") and attach
the tie clip as normal.
Note! Cables must not be attached to drive shafts, or to A/C, fuel or brake lines. Ensure that clipped cables are not rubbing against sharp
edges, or are not positioned too close to a turbo or exhaust pipe due to the risk of heat radiation.
Applies when both engine heater and in-vehicle outlet are installed
-
Mount the branch connector on the bracket using screws and nuts from the kit
-
Lubricate the O-rings with low-temperature grease (P/N 1161427)
