V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Replacing the rear seal
The following components must be removed when replacing the rear seal:
-
the solenoid valves. Lift out from the Air Cleaner (ACL) cover.
-
the air hose from the Air Cleaner (ACL) to the Turbocharger (TC). Place to one side. Seal the hose.
-
place the Air Cleaner (ACL) cover to one side.
-
the charge air pipe over the engine. Seal the openings.
-
the cover over the ignition coils.
-
the upper torque rod bracket.
-
the Camshaft Position (CMP) sensor housing.
-
the trigger wheel.
Replacing the rear camshaft seal
Remove and replace the seal:
Carefully pull out the old seal.
Use extractor 999 5919.
Replacing the rear camshaft seal
Install new seals:
Grease and install the new seal.
