V90 L6-2.9L VIN 96 B6304S (1998)
-
Remove drive flange from output shaft.
-
Use drift to undo nut locking tabs.
-
Remove nut. Use special tool 9995149 as counterhold. Remove drive flange.
-
Use special tool 999 5304 if flange is seized on shaft.
-
On later versions, two washers are installed between flange and housing. Remove and keep for reinstallation.
-
Remove 0-ring from flange.
-
Remove housing bolts (six).
-
Remove housing.
-
Pry off housing using two screwdrivers inserted behind lugs. Remove housing.
-
Remove torque strut from housing.
-
Remove seal. Pry out seal with suitable tool.
-
Remove bearing snap ring.