acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

SRS Indicator Stays On After the Ignition Switch is Turned ON|Page 10540 > < SRS Indicator Stays On After the Ignition Switch is Turned ON|Page 10538
Page 3
background image

16. Disconnect the SRS main harness 2P connector (A) from the driver's under-dash fuse/relay box.
17. Turn the ignition switch ON (II) and wait for 30 seconds. Then turn the ignition switch OFF.
18. Check the No. 2 (10 A) fuse in the driver's under-dash fuse/relay box.

Is the fuse OK?

YES - Short to ground in the SRS main harness; replace the SRS main harness.

NO - Short to ground in the driver's under-dash fuse/relay box; replace the driver's under-dash fuse/relay box.

19. Disconnect the battery negative cable and wait for 3 minutes.

20. Disconnect the driver's airbag 4P connector.

21. Disconnect the front passenger's 4P connector.

SRS Indicator Stays On After the Ignition Switch is Turned ON|Page 10540 > < SRS Indicator Stays On After the Ignition Switch is Turned ON|Page 10538