3.2TL TYPE S V6-3.2L SOHC (2002)
27. Disconnect the SRS main harness 2P connector (A) from the driver's under-dash fuse/relay box.
28. Check resistance between the No. 4 terminal of SRS unit connector B (18P) and the No. 2 terminal of SRS main harness 2P connector. There
should be 0 - 1.0 Ohm.
Is the resistance as specified?
YES - Open in the driver's under-dash fuse/relay box, or poor contact at the SRS main harness 2P connector; check the connection. If the
connection is OK, replace the driver's under-dash fuse/relay box.
NO - Open in the SRS main harness; replace the SRS main harness.
29. Turn the ignition switch OFF.
30. Disconnect SRS unit connector C (8P) from the SRS unit.
