3.2TL TYPE S V6-3.2L SOHC (2002)
Malfunction Lamp / Indicator: Testing and Inspection
The SRS Indicators, But No DTCs Are Stored (NEC SRS Unit Only)
SRS Indicator Circuit Troubleshooting
The SRS Indicators, But No DTCs are Stored (NEC SRS unit only)
NOTE: If not already done, check for DTCs using the SCS menu method before you begin.
1. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds, and then goes off.
Does the SRS indicator stay on?
YES - Go to step 2.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures.
2. Check for blown No. 1 (15 A) fuse in the driver's under-dash fuse/relay box.
Is the fuse OK?
YES - Go to step 10.
NO - Go to step 3.
3. Replace the fuse. Turn the ignition switch ON (II), and check that the fuse doesn't blow.
Is the fuse OK?
YES - The problem has disappeared. Test-drive the vehicle and see Troubleshooting Intermittent failures.
NO - Go to step 4.
4. Turn the ignition switch OFF.
5. Disconnect the battery negative cable, and wait for 3 minutes.
