3.2TL TYPE S V6-3.2L SOHC (2002)
5. Install the mounting cushion (A) on the steering gearbox.
6. Install the mounting brackets (B) over the mounting cushion, then install the 2 gearbox mounting bolts (C). Position the split portion (D) of the
mounting cushion as shown.
7. Install the stiffener plates (E) with the 2 gearbox mounting bolts (F) and 6 stiffener plate attaching bolts (G). Install the bolts loosely first, then
tighten them securely.
8. Center the steering rack within its stroke.
9.
Install the steering joint (A), and reconnect the steering shaft (B) and pinion shaft (C). Make sure the steering joint is connected as follows:
-
Insert the upper end of the steering joint onto the steering shaft (line up the bolt hole (D) with the flat portion (E) on the shaft).
-
Slip the lower end of the steering joint onto the pinion shaft (line up the bolt hole (F) with the groove around the shaft), and loosely install the
lower joint bolt. Be sure that the lower joint bolt is securely in the groove in the pinion shaft.
-
Pull on the steering joint to make sure that the steering joint is fully seated. Then install the upper joint bolt and tighten it.
10. Center the cable reel by first rotating it clockwise until it stops. Then rotate it counterclockwise (approximately 2 and half turns) until the arrow
mark on the label points straight up. Reinstall the steering wheel.
11. Install the steering joint cover (A) with the clamps (B) and clips (C).
