3.2TL TYPE S V6-3.2L SOHC (2002)
12. Connect the return line (A), the feed line (B), to the valve body unit (C). After connecting the fluid lines, make sure that there is no interference
between the lines and other parts.
13. Thread the right and left tie-rod ends (A) and locknut (B) onto the rack an equal number of turns.
14. Wipe off any grease contamination from the ball joint tapered section and threads then reconnect tie-rod ends (A) to the steering knuckles. Install
the 10 mm nut (B) and tighten it.
15. Install the new cotter pin (C) and bend it as shown.