3.2TL TYPE S V6-3.2L SOHC (2002)
-
1 Remove the self-locking nut from the stabilizer link (A).
-
2 Remove the radius rod bolts (B).
-
3 Remove the lower arm mounting bolt (C).
-
4 Remove the lower arm (D) from the rear beam.
6. Install the lower arm in the reverse order of removal, and note these items:
-
Be careful not to damage the ball joint boot when connecting the lower arm to the knuckle. Tighten all mounting hardware to the specified
torque values.
-
Tighten the castle nut to the lower torque value, then tighten it only far enough to align the slot with the hole in the stud. Do not align the castle
nut by loosening it.
-
Use a new cotter pin on the castle nut.
-
Before installing the wheel, clean the mating surfaces on the brake disc and the inside of the wheel.
-
Check the front wheel alignment, and adjust it if necessary.
