CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
8. Set the side plate over the roller, and install it on the pump housing.
9. Set the 5 x 26.8 mm roller in the 5 mm hole in the side plate.
10. Assemble pump rotor to the drive shaft with the "a" mark on the rotor facing upward.
11. Set the 10 vanes in the grooves in the rotor.
NOTE: Be sure that the round ends of the vanes are in contact with the sliding surface of the cam ring.
12. Set the pump cam ring over the two rollers with the "8" mark on the cam ring upward.
13. Apply clean power steering fluid to the vanes and cam ring.