CL TYPE S V6-3.2L SOHC (2001)
Seat Cover: Service and Repair
Front Seat Cover
Front Seat Cover Replacement
SRS components are located in this area. Review the SRS component locations and precautions and procedures before performing repairs or service.
NOTE:
-
Seats with airbags are marked "SIDE AIRBAG" on the seat-back. Because the component parts (seat-back cover, cushion, etc.) of seats with and
without airbags are different, make sure you install only the correct replacement parts.
-
Do not repair the torn or frayed seat-back cover. If necessary, replace the seat-back cover.
-
Take care not to tear the seams or damage the seat covers.
-
Do not touch the OPDS sensor in the seat-back pad, and keep it away from oils. Oils can corrode the sensor causing it to fail.
-
Put on gloves to protect your hands.
Seat-back Cover
1. Fold the seat-back forward.
2. Remove the headrest.
3. Detach the clips (A) and release the hooks (B), then remove the back panel (C).
4. Remove the cap (D) and screws (E), then remove the rear seat access knob (F). Remove the screw (E) and release the hooks (G), then remove the
rear seat access knob trim (H).
5. Driver's seat: Remove the clip (I), then remove the lumber support knob (J).