CL TYPE S V6-3.2L SOHC (2001)
11. Attach the yoke of a universal puller (A) to the steering gearbox mounts with bolts. Clamp the yoke in a vise with soft jaws as shown, then loosen
and remove the cylinder end (B). Do not clamp the cylinder housing or gearbox housing in the vise.
12. Install the bearing separator (A) on the gearbox housing as shown.
13. Place a appropriate size deep socket wrench (B) on the steering rack (C).
14. Set the steering gearbox in a press so the left side points upward, then press the cylinder end seal (D) and steering rack out of the gearbox. Hold
the steering rack to keep it from falling when pressed clear. Be careful not to damage the inner surface of the cylinder housing with the tool.
15. Remove the cylinder end seal from the steering rack.
16. Insert a 24" long, 3/8" drive extension (A) and the special tool into the cylinder from the left side. Make sure that the special tool is securely
positioned on the backup ring edges. Be careful not to damage the inner surface of the cylinder with the special tool.