CL TYPE S V6-3.2L SOHC (2001)
17. Set the gearbox in a press, then press out the cylinder end seal (A) and backup ring (B) from the gearbox.
Note these items when pressing the cylinder end seal:
^
Keep the tool straight to avoid damaging the cylinder wall. Check the tool angle, and correct it if necessary, when removing the cylinder end
seal.
^
Use a press to remove the cylinder end seal. Do not try to remove the seal by striking the tool. It will break the backup ring, and the cylinder
end seal will remain in the gearbox.
18. Carefully pry the piston seal ring (A) and O-ring (B) off the rack piston. Be careful not to damage the inside of the seal ring groove and piston
edges when removing the seal ring.
19. Before removing the valve housing (A), apply vinyl tape (B) to the splines on the pinion shaft (C).
20. Separate the valve housing from the pinion shaft/ valve using a press.
