Legend Coupe V6-2675cc 2.7L SOHC FI (1988)
Yes - Go to step 10.
No - Go to the next step.
9.
Disconnect the connector from the speaker (below the glove box), then check resistance between the terminals on the speaker.
NOTICE:
On LS and GS models, connecting the foot well light connector to the phone speaker will damage the speaker. Check the foot well light. If it
doesn't work because its connector has been switched with the connector for the phone speaker, switch the connectors back where they belong.
Is there about 4.5 ohms?
Yes - Repair the open wire between terminal 2 or terminal 3 of the 7-P connector and the terminals in the speaker connector.[ ]
No - Replace the speaker.[ ]
10.
At the control box 7-pin connector, check resistance between terminal 2 and ground, and terminal 3 and ground.
Is there continuity?
Yes - Repair short to ground.[ ]
No - Go to the next step.
The [ ] symbol indicates the end of troubleshooting for this symptom.
11.
Reconnect the 7-P connector to the control box. Then, with the phone on, backprobe to check continuity between terminal 2 of the 7-P connector
and terminal 6 of the 14-P connector while pressing any key on the handset.
Is there continuity for about 4 seconds after you release the handset key?
Yes - Go to the next step.
No - Replace the control box.[ ]
12.
With the phone still on, backprobe to check continuity between terminal 3 of the 7-P connector and terminal 5ofthe 14-P connector while pressing
any key on the handset.
