Legend Coupe V6-3206cc 3.2L SOHC FI (1991)
69. Apply grease to the circumference of the rack end housing.
70. Install the boots on the rack end with the tube clamps.
NOTE:
-
Coat the rack end groove and inside of the boot with silicone grease.
71. Before installing the boot band, turn up the right and left boots at the gear housing side and adjust the pressure inside the boots to atmospheric
pressure.
NOTE: Install the boot band with the rack in the straight ahead position (i.e. right and left tie-rods are equal in length).
72. Install the boot band so that the locking tabs of the band (stake points) are in the range shown below. (Tabs should face up and slightly forward.)
Left Dust Seal Installation:
NOTE: Viewed from the left side (gearbox side):
