MDX V6-3.7L (2007)
Trim Panel: Service and Repair
Trim Removal/Installation - Pillar Areas
Trim Removal/Installation - Pillar Areas
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
A-pillar Trim
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
-
Follow the A-pillar trim installation procedure carefully; improper installation could cause the side curtain airbags to deploy improperly and
possibly cause injury.
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Take care not to scratch the trim and panels.
-
The upper clip in the A-pillar trim (A) consists of a resin grommet (B) and a metal pin (C). The groove (D) in the grommet secures it to the body
panel (E). The shoulder (F) on the grommet is broken during removal, so the clip must be replaced with a new one when the trim is reinstalled.
1. Pull the front door opening seal away from the A-pillar as needed.
2. Hit the surface of the A-pillar trim (A) with a rubber mallet. The clip is located under the top of the A-pillar trim near the "SIDE CURTAIN
