MDX V6-3.7L (2007)
7. Disconnect the C613 (23P) floor wire harness to rear subframe wire harness connector. Push the wire harness grommet, the wire harness, and the
connector into the passenger compartment.
8. Remove the EVAP canister cover, then disconnect the FTP sensor connector and the EVAP canister shut valve connector. Push the wire harness
grommet, the wire harness, and the connectors into the passenger compartment.
9. Remove the carpet. To remove the carpet, you first need to remove these parts:
^
Seats
^
Door sill trims
^
Kick panels
^
Dashboard undercovers
^
Steering joint cover
10. Remove the left and right B-pillar lower trim.
11. Remove the left and right quarter pillar trim. NOTE: The four upper clips on each quarter pillar trim must be replaced.
12. Remove the left and right rear side trim panels.
13. Remove the center console.
14. Remove the under-dash fuse/relay box.
