MDX V6-3.7L (2007)
NOTE:
^ Refer to the floor wire harness chart/illustration and the illustrations in Floor Wire Harness Removal as needed.
^ Do not bend or twist the new wire harness excessively, and make sure it is not pinched or too loose in any areas.
^ Make sure all connectors on the new wire harness are secure.
^ Replace any damaged interior trim clips.
1. Bring the new floor wire harness and rear wiper hose into the passenger compartment. Place the various wire harness leads and connectors in their
approximate locations.
2. Attach the rear washer hose to the clips on and near the tailgate.
3. Reinstall the six ground bolts in their correct locations on the floor wire harness.
4. Reinstall the rear bracket to the rear HVAC unit.
5. Reinstall the second row seat heater duct, and make sure the mounting clips are secure.
6. Connect the floor wire harness clips and the connectors to the front HVAC unit.
7. Reinstall the third row seat rear heater duct.
