MDX V6-3.7L (2007)
8. At the rear of the vehicle, carefully bend the headliner down, then connect the rear washer hose, the XM antenna connector, and the AM/FM antenna
amplifier connector. Reattach the headliner rear clip.
9. Reinstall the cargo area light.
10. Reinstall the active damper control unit (if equipped), torque the mounting bolts to 9.8 N.m (7.2 lb-ft), and connect the connectors.
11. Reinstall the SH-AWD control unit:
^ Torque the mounting bolt and the mounting nut to 12 Nm (8.7 lb-ft).
^ Connect the control unit connectors.
12. Reinstall the XM receiver:
^ Torque the mounting bolts to 12 N.m (8.7 lb-ft)
^ Connect the receiver connectors.
13. Reinstall the driver's and front passenger's seat belt retractor protectors and the retractors:
^ Torque the retractor upper mounting bolts to 9.8 N.m (7.2 lb-ft).
^ Torque the retractor lower mounting bolts to 32 N.m (24 lb-ft).
^ Connect the retractor connectors.
14. Reinstall the under-dash fuse/relay box, and connect the connectors.
15. Reinstall the center console:
^ Torque the console front mounting bolts to 22 N.m (16 lb-if).
^ Torque the console rear mounting bolts to 9.8 N.m (7.2 lb-ft).
^ Torque the rear blower motor relay mounting bolt, the second row seat heater relay mounting bolt (if equipped), and the ground bolt to 9.8 N~m
(7.2 lb-ft).
^ Connect the parking pin shift connector and the shift lock solenoid connector.
16. Reinstall the left and right rear side trim panels.
17. Reinstall the left and right quarter pillar trim. The four upper clips on each quarter pillar trim must be replaced.
18. Reinstall the left and right B-pillar lower trim.
19. Reinstall the carpet:
^ Do not wrinkle or twist the carpet.
^ Make sure the seat harness connectors are routed correctly.
^ Slip the slits in the carpet over the heater ducts at the second row and third row seats.
^ Properly slip the carpet under the center console, under the B-pillar lower trims, and under the rear side trim panels.
^ Torque the footrest nut to 6 N.m (4 lb-ft).
20. Reinstall the steering joint cover.
21. Reinstall the dashboard undercovers:
^ On the driver's side, attach the harness clip, connect the ambient light connector, and connect the footwell light connector.
^ On the passengers side, connect the ambient light connector, and the footwell light connector.
