MDX V6-3.7L (2007)
22. Reinstall the kick panels.
23. Reinstall the front and rear door sill trims.
24. Reinstall the seats:
^ Connect power seat connectors and the side airbag connectors to the connectors on the front seats.
^ Connect ODS connector to the connector on the front passenger's seat.
^ If equipped, connect the navigation unit connectors to the connectors on the driver's seat.
^ If equipped, connect the seat heater connectors to the connectors on the second row seats.
^ Apply Hondalock 2 Thread lock to the seat bolts, then reinstall the bolts, and torque them to 47 N.m (35 lb-ft)
^ Torque the seat belt lower anchor bolts on the front seats to 32 N.m (24 lb-ft).
25. Insert these parts of the floor wire harness into their openings in the passenger compartment, then push them through to the outside of the vehicle:
^ Middle of floor: EVAP canister shut valve connector and FTP sensor connector
^ Rear of floor: C613 (23P) floor wire harness connector and grommet
^ Rear fenders: Rear damper connectors (if equipped) and rear TPMS initiator connectors
^ Right front fender: rear washer hose and grommet
26. Raise the vehicle on a lift.
27. Connect the EVAP canister shut valve connector and the FTP sensor connector to the EVAP canister. Make sure the wire harness grommet is
securely fitted to the vehicle body.
28. Reinstall the EVAP canister cover, and torque the cover bolts to 22 N.m (16 lb-ft)
29. Connect the C613 (23P) floor wire harness connector to the rear subframe wire harness connector. Make sure the wire harness grommet is securely
fitted to the vehicle body.
30. Connect the rear damper connectors (if equipped) and the rear TPMS initiator connectors. Make sure the wire harness grommet is securely fitted to
the vehicle body.
31. Reinstall the rear fender covers:
^ Torque the wheel arch bolts to 9.8 N.m (7.2 lb-ft).
^ Replace any damaged mounting clips.
32. Attach the new rear washer hose to the existing hose inside the right front fender. Make sure the hose grommet is securely fitted to the vehicle body.
33. Reinstall the right front fender cover:
^ Torque the front lower bolt to 9.8 N.m (7.2 lb-ft).
^ Replace any damaged mounting clips.
34. Reinstall the right front inner fender.
35. Reinstall the wheels.
36. Reconnect the negative cable to the battery.
37. Test-drive the vehicle, and make sure that all vehicle systems and controls work properly.
38. Use the HDS to check for DTCs, and clear any that you find.
Floor Wire Harness (Left Branch)
