MDX V6-3.7L (2007)
11. Install the seat belt in the reverse order of removal, and note these items:
-
Apply medium strength type liquid thread lock to the anchor bolts before reinstallation.
-
Tighten the bolts by hand first, then tighten to the specified torque.
-
Check that the retractor locking mechanism functions as described.
-
Assemble the washer, collar, and bushing on the upper anchor bolt as shown.
-
If the seat belt tensioner has been deployed, replace the front seat belt protector with a new one.
-
Before installing the anchor bolts, make sure there are no twists or kinks in the seat belt.
-
Make sure the seat belt tensioner connector is properly plugged in.
-
Reconnect the negative cable to the battery.
-
Enter the anti-theft codes for the audio and the navigation system (if equipped).
-
Set the clock.
-
Check for any DTCs that may have been set during repairs, and clear them.
-
Do the steering column position memorization.
Seat Belt Buckle
1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped).
2. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
3. Remove the front seat.
4. Remove the center cover.
5. Lift up the front seat, then disconnect the seat belt buckle switch connector (A) and detach the harness clip (B). The driver's seat is shown; the
passenger's seat is similar.
6. Remove the center anchor bolt (A) and detach the harness clips (B), then remove the seat belt buckle (C).
