MDX V6-3.7L (2007)
7. Pull the seat belt buckle switch harness (D) out through the space between the seat cushion and the seat linkage.
8. Install the buckle in the reverse order of removal, and note these items:
-
Assemble the washers on the center anchor bolt as shown.
-
Apply medium strength type liquid thread lock to the center anchor bolt before reinstallation.
-
Tighten the bolts by hand first, then tighten to specification with a torque wrench.
-
Make sure the seat belt buckle switch connector is plugged in properly.
-
Reconnect the negative cable to the battery.
-
Enter the anti-theft codes for the audio system and the navigation system (if equipped).
-
Set the clock.
-
Check for any DTCs that may have been set during repairs, and clear them.
-
Do the steering column position memorization.
