MDX V6-3.7L (2007)
5. Remove the upper anchor bolt (B).
6. Detach the clip (A) by pulling the bottom of the quarter pillar trim (B) back. While holding the trim away from the C-pillar, pull the second row
seat belt, upper anchor (C), tongue plate (D), and the lower anchor (E) into the trim, and pull the entire second row seat belt down.
7. Remove the upper retractor mounting bolt (A) and the lower retractor bolt (B), then remove the front seat belt (C) and retractor (D). The left
second row seat belt is shown; the right second row seat belt is similar.
8. Install the seat belt in the reverse order of removal, and note these items:
-
Apply medium strength type liquid thread lock to the anchor bolts before reinstallation.
-
Tighten the bolts by hand first, then tighten to the specified torque.
-
Check that the retractor locking mechanism functions.
-
Assemble the washers, collar, and bushing on the upper anchor bolt as shown.
-
Before installing the anchor bolts, make sure there are no twists or kinks in the front seat belt.
Left Seat Belt Buckle