MDX V6-3.7L (2007)
10. Align the socket holder (A) on the shift cable (B) with the slot in the bracket base (C) then slide the holder into the base. Install the shift cable end
(D) over the mounting stud (E) by aligning its square hole (F) with the square fitting (G) at the bottom of the stud. Push the holder until it snaps
securely in place. Do not install the shift cable by holding the shift cable guide (H) and damper (I).
11. Verify that the shift cable end (A) is properly installed on the mounting stud (B).
12. If improperly installed, remove the shift cable from the bracket base, and reinstall the shift cable. Do not install the shift cable end on the mounting
stud while the shift cable is on the bracket base.
13. Install and tighten the nut.
