MDX V6-3.7L (2007)
15. Cut a "V" in the end of the nozzle (A) on the adhesive cartridge as shown.
16. Pack adhesive into the cartridge without air pockets to ensure continuous delivery. Put the cartridge in a caulking gun, and run a bead of adhesive
(A) around the edge of the front seal (B) and molding (C) as shown. With the glass primer (D) you applied in step 13 on the quarter glass (E) as a
guide, apply the adhesive to the upper and lower corner portions of the quarter glass. Apply the adhesive within 30 minutes after applying the
glass primer. Make a slightly thicker bead at each corner.
17. Use suction cups (A) to hold the quarter glass (B) over the opening, align the clips or the alignment marks (C) made in step 11, and set it down on
the adhesive. Lightly push on the quarter glass until its edges are fully seated on the adhesive all the way around.
