MDX V6-3471cc 3.5L (2002)
Rear Door Panel: Service and Repair
Rear Door Panel Removal/Installation
Special Tools Required
Trim pad remover. Snap-on A177A or equivalent, commercially available.
1. Remove the inner handle (A). Take care not to scratch the door panel.
1. Pry out the cap (B), and remove the screw.
2. Move the inner handle forward and half-way out, then disconnect the inner handle rod (C).
2. Detach the clips (A) and release the hooks (B), then remove the switch panel (C). Take care not to scratch the door panel. Disconnect the power
window switch connector (D).
3. Pry out the cap (E), and remove the screw (F).